Slicer Discord
Geocache GPS  Device – 3D-Druckmodell von MakerWorld MakerWorld
Other Hobby & DIY

Geocache GPS Device

44 Downloads
14 Likes
22 Makes
Zum Modell
I made this cache container to hide on the upcoming blue switch day on May 2nd. It holds two paper log sheets with the included roller pin, I used the 2.5inch version from https://techblazer.com/. On the bottom are four holes for 10*2mm magnets.A 10*2mm O-ring can be put below the thread for better water resistance.
Kategorie
Other Hobby & DIY
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Polycarbonate
Mindest-Druckbett
50 mm (Klein)
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

4 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen