Slicer Discord
Geocache Nano  – 3D-Druckmodell von MakerWorld MakerWorld
Sport & Outdoors

Geocache Nano

12 Downloads
6 Likes
6 Makes
Zum Modell
I made this Geocache Nano that uses 18 mm caps from those small bottles of alcohol.Screwing it on the first time is a bit hard; after that, it works perfectly.For the logbook i used the one linked below (not my creation)https://www.gclogbuch.de/count.php?link=https://www.bergziege-owl.de/wp-content/uploads/2021/03/Nano-Logbuch.pdf&nr=006&groe=nano There are 3 versions at the moment:Magnet version (10x2)Cord hole Cord hole on the undersideBoost MeA boost supports my work so i can make more like this
Kategorie
Sport & Outdoors
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen