Thingiverse
Geocache Preform Dispenser
von charly4
49
Downloads
28
Likes
0
Makes
This mechanism releases a bottle preform in an electronic gadget cache. It uses a 9g servo (SG9) and 4 screws 3.5 * 16 mm.
The box can be glued to the mount. And this can be glued into the birdhouse. Super glue (cyanoacrylate) works very well for PLA. Epoxy should work also.
The spring is derived from “Accordion folded customizable spring”.
https://www.thingiverse.com/thing:980377
Accordion Length 52
Accordion Folds 20
Accordion Width 11
Accordion Height 11
Accordion Sheet Thickness 0.5
Accordion Right Angle Ends: To both sides
Reinforcement For Ends: No
1-hole
Hole 1: Circle
Hole 1 Diameter 8
Hole 1 Rotate 45
Hole 1 X Position 0
Hole 1 Y Position 0
Video:
https://youtu.be/XtjUOcepa-8
“Behind the Cache” made a birdhouse using this mechanism.
https://youtu.be/C2H1XU1Sllo
The box can be glued to the mount. And this can be glued into the birdhouse. Super glue (cyanoacrylate) works very well for PLA. Epoxy should work also.
The spring is derived from “Accordion folded customizable spring”.
https://www.thingiverse.com/thing:980377
Accordion Length 52
Accordion Folds 20
Accordion Width 11
Accordion Height 11
Accordion Sheet Thickness 0.5
Accordion Right Angle Ends: To both sides
Reinforcement For Ends: No
1-hole
Hole 1: Circle
Hole 1 Diameter 8
Hole 1 Rotate 45
Hole 1 X Position 0
Hole 1 Y Position 0
Video:
https://youtu.be/XtjUOcepa-8
“Behind the Cache” made a birdhouse using this mechanism.
https://youtu.be/C2H1XU1Sllo
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
