Thingiverse
Geoffs Ender 3 Auto Level Bracket for an Inductive Sensor
von geoff_cohen
38
Downloads
26
Likes
0
Makes
My take on an Auto Level Bracket for an Ender 3 - unlike most other designs you don't need 2 spanners, as the top Nut has it's own hex nut Holder space - only 1 spanner to tighten the nut.
There's also a groove in the top to support the wire and prevent it getting caught on something.
Uses a standard 12mm Inductive Sensor (LJ12A3-4-Z/BX) , the bracket is designed so the nuts are (roughly) in the center of the threaded part.
There's also a groove in the top to support the wire and prevent it getting caught on something.
Uses a standard 12mm Inductive Sensor (LJ12A3-4-Z/BX) , the bracket is designed so the nuts are (roughly) in the center of the threaded part.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!