Thingiverse
GH4 Bottom Cover
by jknorr
4
Downloads
5
Likes
0
Makes
Just a simple replacement part for one of the bottom covers of the Panasonic GH4.
It is a small part so depending on the material used for printing there is a risk of pieces breaking off. I printed it with PLA and had no problems so far but other materials may be more suitable.
The printed part should have a length of ~14mm and a width of ~3.2mm in order to fit perfectly. (see photos)
It is a small part so depending on the material used for printing there is a risk of pieces breaking off. I printed it with PLA and had no problems so far but other materials may be more suitable.
The printed part should have a length of ~14mm and a width of ~3.2mm in order to fit perfectly. (see photos)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!