Ghoul Blade Handle

A handle for a knife without one, i had a blade with a blank tang and designed this for it, similar shaped tangs should work for this. I had to epoxy and clamp down the handles to the blade to make it work. The ring at the hilt broke off cuz it was too thin, so i added extra fortifications to the ring to prevent it from happening to you lol.

There's a coffin shaped hole i put in the handle and made a tiny skeleton to fit inside it, glass printbeds work best for this one to make the skeleton look its best.

The hexagon holes were for a nut & bolt to go through on both sides but i didnt end up needing bolts with enough epoxy. Use packing tape pressed firmly against the skeleton side of the handle to prevent it from dripping out when you pour in the epoxy, then set the tang of the blade into the epoxy lining it up with the teeth of the skull at the top, let dry. Then put tape on the second handle, fill it with epoxy and then press the knife and handle ontop of it while aligning ever