Giant C9 bulb

I took BenitoSanduchi's Geaornament and printed at 220% with a brim which prints just fine on Ender3 Pro. I printed with zero infill, 0.2 layer height, zero bottom layers, and two line wall count in Cura. The Spiral setting in Cura made the walls too thin for my liking. I then made a new base for the top in Tinkercad. I made two different bases. One has two holes for the wires and one has just one hole for the end of the chain. Both bases have a loop hole for hanging them with a string. The bases were printed with 20% infill and 0.2 layer height. I used a Dig Uno for controller and square 1.4" x 1.4" leds from Holidaycoro. I spray painted the bases black and drilled two opposing holes in the base with the C9 inserted to screw in m4 screws so I can access the inside if need be and to hold the C9 in place. I sealed the top holes with hot glue.