Thingiverse

Giant Magnet Pin

by I_need_a_better_name

14 Downloads

11 Likes

0 Makes

I had a 1.375x0.19 inch magnet left over from another project. It was stuck to the storage shelves in my office, languishing. It is too large and powerful to use on its own so I whipped up a "push pin" so it could go on the fridge.

I highly encourage using epoxy, or another strong glue, to retain this in the pin. They're surprisingly strong, and prone to departing the pin at high speed if not glued. Superglue is not strong enough. Trust me.

Magnet: [https://amzn.to/2zkP2zX](https://amzn.to/2zkP2zX)
TIANSE Green PLA Filament: [https://amzn.to/2MUN4bw](https://amzn.to/2MUN4bw)
Loctite E-20HP Hysol Epoxy: [https://amzn.to/2J4AFQ2](https://amzn.to/2J4AFQ2)
Loctite "Epoxy Gun": [https://amzn.to/2KZwS8y](https://amzn.to/2KZwS8y)
Epoxy Nozzles: [https://amzn.to/2KTYVWN](https://amzn.to/2KTYVWN)

fridge magnet giant magnet magnet pin magnetic magnetic push pin push pin refridgerator refridgerator magnet fridge magnet giant magnet magnet pin magnetic magnetic push pin push pin refridgerator refridgerator magnet

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Why?

significant post-processing

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 2/3

Printer