MakerWorld
Hand Tools
Vai al Modello
Giant Nut & Bolt
3.3k
Download
1.4k
Likes
2.1k
Makes
This set is a great statement piece! Although not intended for actual use, they are sized properly to meet standards for an M64 nut and M64x150 bolt (ISO4032 & ISO4762 respectively). I have also included the proper allen key (46mm) needed to install the bolt. The allen key has 3 main components, along with 2 pins to hold everything together:Section 1 - Tool EndSection 2 - Middle PieceSection 3 - Ball EndPin - Print twicePlease see the assembly instructions below. Print SettingsAll pieces print fine without supports or any special settings. For best print results, print all pieces in the orientation as they come. Although not required, I reduced infill in most areas. However, I used a higher infill percentage below all top surfaces. Allen Key Assembly The following filament was used in the pictures above:Bambu Lab Matte Charcoal PLA
JamesThePrinter pubblica anche su
48 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
