Thingiverse
Gilbert Engineering XLS450 Flake 46" Mounts
von agent462
5
Downloads
2
Likes
0
Makes
Mounts for the Gilbert Engineering XLS450 Flake 46" Mounts. This uses 1/2" EMT.
If using the center mount, print two
There are mounts for the right and left side bottom and upper. You could use these without the center or with. If using the center, you could just use the bottom of the left and right to prevent spinning.
If using the center mount, print two
There are mounts for the right and left side bottom and upper. You could use these without the center or with. If using the center, you could just use the bottom of the left and right to prevent spinning.
agent462 veröffentlicht auch auf
71 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!