Thingiverse
Gimbal clock
door NilsR
1
Downloads
1
Likes
0
Makes
A stand for this clock module:
http://www.conrad.de/ce/de/product/641871/DCF-77-Funkuhren-Modul
(or any module that fits in a 49mm x 24mm frame)
Designed in SketchUp Make.
You will need three M3x16 bolts, three M3 nuts, and four 3.2mm washers for assembly. I recommend assembling the stand first, and then inserting the module.
I had to allow for some tolerance between the outer frame and the module holder; if it is too large, then just add a washer on one side.
http://www.conrad.de/ce/de/product/641871/DCF-77-Funkuhren-Modul
(or any module that fits in a 49mm x 24mm frame)
Designed in SketchUp Make.
You will need three M3x16 bolts, three M3 nuts, and four 3.2mm washers for assembly. I recommend assembling the stand first, and then inserting the module.
I had to allow for some tolerance between the outer frame and the module holder; if it is too large, then just add a washer on one side.
NilsR publiceert ook op
15 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!