Thingiverse
Giottos Rocket Blaster Dust Filter
von Department_Nine
4
Downloads
17
Likes
0
Makes
Air filter that stops dust getting sucked into the blower: clean air going in = clean air going out.
It has a large filter area, is tough and reliable. Prints without supports.
Cut an 65mm diameter circle out of a face mask (trace around the body). Put it in the lid and then assemble the two halves. Push/wiggle the assembly onto the bulb's base inlet (spit helps).
Check out more things from Department_Nine!
It has a large filter area, is tough and reliable. Prints without supports.
Cut an 65mm diameter circle out of a face mask (trace around the body). Put it in the lid and then assemble the two halves. Push/wiggle the assembly onto the bulb's base inlet (spit helps).
Check out more things from Department_Nine!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!