Glass Bed Containment

I don't like clips .......They seem like a meh solution. You now what I mean? Do they work? MEHHHH yeah.. They seem so inelegant there must be a better way! I'm tired of taking the handles off my clips! No more clips flying off hitting my dog when the hotend crashes into them! So the idea is to keep the glass captive and clean up the print bed. If you don't like the 1.45 mm gap under your bed print a mat of the same thickness. The first print didn't go well so i basically split the part. Print with a raft and use a high infill percentage, and print standing up(also easier to print multiples i think) for strength. Listen I'm no expert so your mileage may vary. I tested for fitment and it seemed fine if your using PLA you might consider the old "Shake and Bake" routine .....you know 100 C for an hour or so.

I revised the part with a closer tolerance to fit tighter to the bed so print one of each. Then check for fitment. Keep in mind these parts will separate your glass from your prin