Glass Extruder

The Glow Extruder! Designed for use with all types of filaments, and the ability to change filament in the dark. I used Overture Clear PETG. The LEDs were installed below the extruder embedded in my extruder mount/platform. This extruder is very rugged and just works with anything you put in it, Very smooth and problem free for 3 months and running. I print most often with TPU (Formfutura), PETG (Overture), PC-Carbon (Priline) and Nylon Carbon (NylonX). The spring was costum fit with trial and error, but once I found the right length It hasn't needed to be adjusted at all.

I'm working on an ALL IN ONE Tevo Tornado linear rail Kit, the LED extruder mount will be included.

Hardware :

12x4mm grooved guide bearing
1 M4 11mm
2 M4 washers for the gape at the top of the guide bearing and idler arm cover
1 Bowden tube connector 10mm thread