Glass Retainer Clips small 2pc version

I wanted some glass clips. I saw some to download but none of them were exactly what I was looking for. I whipped these up in fusion 360. They are designed for an inset of 5mm from the back of the frame to the glass. Use #4 panhead wood screw for install, I used 1/2" length ones.

It's a 2 piece design. The one in the picture is wood PLA and TPU. Keep in mind that these are not very strong individually, so you should use quite a few of them. I did 8 of them on that small window of about 14" x 18". PETG would probably be a better choice than PLA, honestly.

I used a dual extruder printer and printed them all at once, but I would think you can print them separately and glue these as well. You may not even need glue since the screw will hold them in together anyways. I haven't tested the fit tolerance, nor have I build in any tolerance so you may need to scale the soft piece down a little for a good fit.