Thingiverse
Glide bar for Liam
von Basjohan
4
Downloads
2
Likes
1
Makes
**Update** added a new version with a 10° angle to glide better over grass.
My version of a glide bar for Liam (https://www.facebook.com/groups/319588508137220/).
Original version was bolted to the sides of the box, and slightly too big for my printer (20cm circular bed). So I designed a version that bolts to the bottom instead, and is just as wide as the box that is Liams Body.
If you decide to remix it in OpenSCAD I recommend disabling the Minkowski function used to create round edges, it takes a couple of minutes to render with it activated ;)
My version of a glide bar for Liam (https://www.facebook.com/groups/319588508137220/).
Original version was bolted to the sides of the box, and slightly too big for my printer (20cm circular bed). So I designed a version that bolts to the bottom instead, and is just as wide as the box that is Liams Body.
If you decide to remix it in OpenSCAD I recommend disabling the Minkowski function used to create round edges, it takes a couple of minutes to render with it activated ;)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
