Thingiverse
Glock Case Ammo Holder
door Kyle5293
8
Downloads
15
Likes
0
Makes
Insert to fit the OEM Glock Case, in this scenario, the one that comes with the 43x. Each half holds 54 rounds, for a total of 108. Split into 2 pieces to allow for customization and to fit print bed.
2 hole cutouts are on opposite edges to allow for a magnet to be placed in for the lid. The lid is not necessary and the rounds will stay secure without it while inside the case. I made a lid so if the case was opened upside-down, it wouldn't lead to a mess.
This only fits 9mm, since that is what it was made for.
2 hole cutouts are on opposite edges to allow for a magnet to be placed in for the lid. The lid is not necessary and the rounds will stay secure without it while inside the case. I made a lid so if the case was opened upside-down, it wouldn't lead to a mess.
This only fits 9mm, since that is what it was made for.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
