Slicer Discord
Glow Coaster – Modelo 3D imprimible de MakerWorld MakerWorld
Other House Models

Glow Coaster

25 Descargas
14 Likes
13 Makes
Ver Modelo
This coaster lights up when you place your glass on it.Parts and AssemblyThe piece consists of 3d Printed parts as well as a few things everybody should find in their house.The two Screws I found in a box of old dissassemblied electronics. The size is roughly 4 mm long and 1.5 mm in diameter.The filler is mainly here for pushing the LED assembly in place. I ended up not putting it in the final build because it was slightly to high.LED AssemblyThe LED is from a standard 5050 LED strip. I desoldered it from a piece I had laying around. Then I took a paperclip and straightened it with pliers, I then soldered the wire paperclip to the led and made bends according to the following sketch.Note: The 5050 LED actually houses 3 individual LEDs thats why there is 3 soldering points. To lower the brightness and energy consumption you could just solder 1 or 2 solderpoints to the wire.AssemblyStart by pushing the LED Assembly in the Main Body. Use the filler cube to make shure you push it in all th
Categoría
Other House Models
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Postprocesado
Tornillería
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

MrHegger también publica en

53 modelos adicionales en 1 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección