Glowing lampshade

!!! IMPORTANT slicing settings!!! read first:

This model was made to be printed with a 1,00 mm nozzle. You need a extrusion width (or at least a perimeter width) of 1,20 mm, otherwise the perimeter will not align

You have to set diffrent slicing settings for the first 4,80 mm print height:
0.00 mm - 4.80 mm : 2 perimeter, not top layer, no bottom layer, hexagonal infill 15-20 %
4.80 mm - end : vase mode (or 1 perimeter, no top layer, no bottom layer, no infill )

Here is a video, switching light on / off:

https://www.dasfilament.de/blog/detail/sCategory/6/blogArticle/121