Glueless model rocket (spinning for stability)

A glueless (mostly, rubber band must be glued to the inside) model rocket. It is easy to use. If PLA is used for main body and engine housing it could melt and be a one-time rocket so I recommend using PETG or ABS or other high temp resistant plastics. If any issues are found I will fix them. The nose cone may need to be sanded down at the bottom to fit in the rocket this is so that you can get a good fit you don't want it to be too loose, but you also don't want it to be too tight.The garbage bag is used as the parachute, Cut out a circle and stab 6 holes around the outside edge. Feed the string through the holes on opposing sides after feeding it through the nose cone. You can then cut the rubber band and glue it to the inside of the rocket around ½ inch down. Then tie it to the nose cone. Then it is just like your average model rocket.