Thingiverse
GM 3800 V6 Temperature Sensor Cable Bracket
por SeeingInGreen
9
Descargas
3
Likes
0
Makes
I made this to replace a plastic cable clip/bracket on my 2001 Monte Carlo SS's 3800 V6 engine. This bracket secures the temperature sensor cable to one of the bolts on the engine coolant intake. I'm not sure if all 3800s use this bracket, but over time the one on my car wore out and crumbled apart. This replacement bracket goes in place of the other one, and I secured it to the cable by wrapping it with electrical tape. I printed it with PLA on a Makerbot Replicator 2 and so far it has stood up well to the high engine temps (remember this is in constant contact with engine metal). It may be beneficial to experiment with scaling this model up or down a little to better fit your car. I would also recommend printing with 100% infill.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!