Slicer Discord
GM trunk latch cover – Modèle 3D imprimable de MakerWorld MakerWorld
Vehicles

GM trunk latch cover

1 Téléchargements
1 Likes
0 Makes
Voir le modèle
This replaces the small cover for the trunk latch, GM part T10618 23439181. The tabs broke off mine while I had the interior hatch panels off for maintenance on my 2017 Chevrolet Volt. GM apparently doesn't sell this interior trim piece any more so, while it's not critical, I still thought I'd give a shot at replicating it. It's not entirely the same as the original, but it still snaps in just fine. The fit is snug and takes a little pressure to push in, but it will stay in place afterward. The part number should apply to all 2016-2019 Chevrolet Volts, possibly other GM vehicles of that era. Let me know in the comments if this proved useful for anybody.
Catégorie
Vehicles
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Débutant Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA, ABS
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection