Thingiverse
GNX-MFH Bases
von camioincogneato
3
Downloads
4
Likes
0
Makes
GNX-MFH Bases for VKB flightsim related products
The standard device holder from VKB (the GNX-MFH) has a fairly large footprint on the desk, mine on the other hand has a much reduced footprint and uses standard GoPro mounting accessories to allow adjustment to your hearts desire.
Use one or the other of the included bases.
Print 2x bases and 2x support arms and 2x MFH frames (small,1x mirrored) or use the larger frame. An infill of 20% or more should be fine.
If more stability is required to keep from twisting a 45mm block bolted between the 2x arms can be used.
Extra GoPro mounting accessories can be used (and/or printed) if desired.
Original GNX-MFH image for comparison included bellow.
NOTE: Added a large MFH frame that joins 2x smaller frames with the addition of another GoPro mount for extra devices (eg Tobii etc) as well as a base for other mounting accessory. I suggest you use support (touching buildplate).
The standard device holder from VKB (the GNX-MFH) has a fairly large footprint on the desk, mine on the other hand has a much reduced footprint and uses standard GoPro mounting accessories to allow adjustment to your hearts desire.
Use one or the other of the included bases.
Print 2x bases and 2x support arms and 2x MFH frames (small,1x mirrored) or use the larger frame. An infill of 20% or more should be fine.
If more stability is required to keep from twisting a 45mm block bolted between the 2x arms can be used.
Extra GoPro mounting accessories can be used (and/or printed) if desired.
Original GNX-MFH image for comparison included bellow.
NOTE: Added a large MFH frame that joins 2x smaller frames with the addition of another GoPro mount for extra devices (eg Tobii etc) as well as a base for other mounting accessory. I suggest you use support (touching buildplate).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!