Goddess

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 4.5mm Filaments Used:PLA BambuLab Basic Black Transmission Distance: 0.6PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA BambuLab Basic Jade White Transmission Distance: 5PLA BambuLab Basic Silver Transmission Distance: 0.5PLA BambuLab Basic Green Transmission Distance: 2PLA BambuLab Basic Light Green Transmission Distance: 2This print uses 6 unique filaments. Substitute as needed. Swap Instructions:Start with BlackAt layer #12 (1.04mm) swap to Blue GrayAt layer #20 (1.68mm) swap to Jade WhiteAt layer #31 (2.56mm) swap to SilverAt layer #32 (2.64mm) swap to BlackAt layer #37 (3.04mm) swap to GreenAt layer #41 (3.36mm) swap to Light GreenAt layer #49 (4mm) swap to Jade White for the rest.Boost MeGot a Boost to spare? Every little bit helps