Slicer Discord
Godox iT30 Pro MagMod Adapter – Modelo 3D imprimible de MakerWorld MakerWorld
Electronics

Godox iT30 Pro MagMod Adapter

10 Descargas
6 Likes
2 Makes
Ver Modelo
The real MagGrip from MagMod doesn't fit the Godox iT30 Pro very well. It can't go on all the way and even if it did, it blocks all the ports forcing you to take off the mag grip every time you want to charge the flash. This adapter fits snugly onto the flash and has cutouts for the charging port and wide/narrow toggle selector. Simply press in a stack of four 10x5x2mm rectangular magnets into each side using a vice. Make sure you check the magnet's polarity against the MagShpere before pressing in the magnets! Now you can use your MagMod accessories with the Godox iT30 Pro!
Categoría
Electronics
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Postprocesado
Tornillería
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

The Reverse Engineer también publica en

33 modelos adicionales en 1 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección