MakerWorld
Sculptures
Go to Model
Gohan SSJ2 Statue DBZ
429
Downloads
269
Likes
208
Makes
Hello again! I have scanned and edited an SSJ2 Kid Gohan statue. It uses a decent amount of tree support, so make sure to be careful when removing the hair.Tested on A1 miniI would advise putting some sticky tack or double-sided tape for more stability of the figureSorry for the delay, my A1 mini is being unreliable. I might use up my points to buy the full A1.Boost MeSupport me if you would like :)Thank you for all of your support and feedback, I have more models on the way!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!