Thingiverse
Golden Snitch Ring Box
von xtchronosage
3.5k
Downloads
3.3k
Likes
31
Makes
Long overdue upload: Remix of Porda's Golden snitch as a ring box! :)
Note that this is the life-size version. The box has a 3.2 cm diameter empty space inside where you can place small items (such as a small ring). Mesh stl files were modified with Blender 3D. Wings are the same as the ones in the original link.
PRINTING:
-Top.stl and bottom.stl pieces: Pretty straightforward. Use a brim for better adhesion.
-Hinge.stl : Print the hinge with a brim (for bed adhesion)(hole side down) and -0.1 to -0.15mm vertical shell offset/horizontal size compensation (IMPORTANT!), then glue the flat part to the rear center portion of the top half (where the hinge is).
-Top_with_Hinge.stl: This is the top half version with the hinge. You can print this if you're having trouble joining the hinge with the top half. You may need to print it with supports (hinge side down)(don't forget the vertical shell offset!), then sand the bottom, of the hemispheres smooth. :)
-Paint all parts before as
Note that this is the life-size version. The box has a 3.2 cm diameter empty space inside where you can place small items (such as a small ring). Mesh stl files were modified with Blender 3D. Wings are the same as the ones in the original link.
PRINTING:
-Top.stl and bottom.stl pieces: Pretty straightforward. Use a brim for better adhesion.
-Hinge.stl : Print the hinge with a brim (for bed adhesion)(hole side down) and -0.1 to -0.15mm vertical shell offset/horizontal size compensation (IMPORTANT!), then glue the flat part to the rear center portion of the top half (where the hinge is).
-Top_with_Hinge.stl: This is the top half version with the hinge. You can print this if you're having trouble joining the hinge with the top half. You may need to print it with supports (hinge side down)(don't forget the vertical shell offset!), then sand the bottom, of the hemispheres smooth. :)
-Paint all parts before as
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!