Thingiverse
Golf ball alignment tool - Callaway ERC *like*
by apex05
90
Downloads
50
Likes
0
Makes
Do you like the Callaway ERC golf ball alignment lines but don't want to shell out $50 for a dozen of them? Print this!
Please be aware that you'll probably need to mess with your slicer settings to get this to print right. I went through 4 copies with different settings before I printed a good one.
I rotated it 90* and used line supports for just the middle section (so that the support lines went across the two middle bars)
40% percent overhang angle
15% support density
YMMV
You'll more than likely need to file and sand away any burrs that get left behind.
Use a standard rubber band through the two holes to hold the ball in place while marking the lines
Please be aware that you'll probably need to mess with your slicer settings to get this to print right. I went through 4 copies with different settings before I printed a good one.
I rotated it 90* and used line supports for just the middle section (so that the support lines went across the two middle bars)
40% percent overhang angle
15% support density
YMMV
You'll more than likely need to file and sand away any burrs that get left behind.
Use a standard rubber band through the two holes to hold the ball in place while marking the lines
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!