Golf Disc "Cobra"

*Look at the photographs provided for more clarity on the instructions.

** I printed both the PLA and the TPE at 212ºC with the bed heated to 53ºC

I attempted to make a golf disc using "3D Solutech Flexible" filament (TPE), as you can see in the photographs the results were terrible. The supports made a mess of the surface and it did not print the outer ring well.
I had the idea to try it by using a support made of PLA, then print the TPE inside of that, and it worked very well.
The PLA support ring is the support so do not use supports on neither file when slicing.
The TPE file make sure to use 100% infill.
The original Innova disc says they will weigh between 150-180g, according to Cura this disc weighs 181g using 100% infill.

A couple measures need to be taken prior to printing the TPE file;

1. DO NOT print any purge lines, the fan housing or nozzle could hit the PLA support ring.
(Depending on the size of your print bed this may not be an issue, the disc has a