Thingiverse
Golf Range Finder Carry Case
von gavmeister
3
Downloads
8
Likes
0
Makes
This is a 2 part range finder carry case with place for spare battery.
Best printed with PETG for strength.
Uses 4 x 5mm x 3mm magnets to keep the lid closed, press fit with a drop of super glue
Assembly is easy , just use a paper clip to slide into both hinge parts and a bit of superglue to keep the ends in place followed up with a bit of melted filament to tidy up.
Best printed with PETG for strength.
Uses 4 x 5mm x 3mm magnets to keep the lid closed, press fit with a drop of super glue
Assembly is easy , just use a paper clip to slide into both hinge parts and a bit of superglue to keep the ends in place followed up with a bit of melted filament to tidy up.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
