Slicer Discord
Gonggi – 3D-Druckmodell von MakerWorld MakerWorld
Other Toys & Games

Gonggi

34 Downloads
16 Likes
9 Makes
Zum Modell
Rules: 1. Basic Setup:The stones are placed on the ground, and the game is typically played by two or more players. Players take turns tossing and catching the stones.2. Objective:The goal is to perform a series of moves without dropping any stones, with increasing difficulty. The game is divided into different stages, and each stage is marked by a specific set of moves.3. Common Rounds:One at a time (1 Gonggi): The player tosses one stone onto the ground and quickly picks up a single stone from the ground with their fingers (usually the same hand) while maintaining control. The player continues this process and must finish without dropping any stone.Two stones at once (2 Gonggi): The player needs to pick up two stones from the ground at the same time in various ways.More complex combinationns: As players advance, more complicated patterns and hand movements are introduced, such as picking up three or more stones at once, creating more challenges.4. Stages:The game usually progresses i
Kategorie
Other Toys & Games
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

Drew veröffentlicht auch auf

53 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen