Gooblet

#Gooblet

##Just a silly little guy.

Based on a design by [Icoso](https://www.youtube.com/@icoso).

###Instructions

Requires:
- 2 x 10mm googly eyes
- 4 small pieces of 1.75mm filament (~15mm long) for legs and antennae

Print the body and two antennae. If you want the Gooblet to stand up, you’ll also need to print the base.
The body requires supports, but the other pieces do not.

Most of the assembly should be friction-fit, except for the eyes, which can be superglued. If any parts are too loose, you can add a bit of glue to secure them.