Thingiverse
Goofy Pumpkin
door DRPrinting3D
14
Downloads
19
Likes
0
Makes
A hollow pumpkin I designed with a goofy face on it. I used a small section of a white 12V LED strip on the top then glued the two pieces together. There is a small hole in the rear of the base to allow you to run a cable out of the back.
**Note:** The small arrow in the bottom of the top piece points toward the crease in the face.
**Note:** The small arrow in the bottom of the top piece points toward the crease in the face.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!