Thingiverse
Google AIY Voice Snapbox
por burntcrispy
39
Descargas
36
Likes
1
Makes
This a case for the google AIY voice kit.
It is designed in 6 pieces, each to to be printed laying down.
There are catches on the top and bottom pieces, going into notches on the front and back sides holding the whole thing together.
The mic PCB and speaker also snap into place using plastic catches.
I used the standoffs that came with the kit; They sit in rings on the bottom piece, keeping the raspberry pi from sliding side to side, or pushing in when plugging in the USB.
The back side keeps the raspberry pi from moving up and down and needs to be inserted at the same time as the pi.
The SD card is accessible from the outside (remember to remove during assembly).
It is designed in 6 pieces, each to to be printed laying down.
There are catches on the top and bottom pieces, going into notches on the front and back sides holding the whole thing together.
The mic PCB and speaker also snap into place using plastic catches.
I used the standoffs that came with the kit; They sit in rings on the bottom piece, keeping the raspberry pi from sliding side to side, or pushing in when plugging in the USB.
The back side keeps the raspberry pi from moving up and down and needs to be inserted at the same time as the pi.
The SD card is accessible from the outside (remember to remove during assembly).
burntcrispy también publica en
7 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
