Thingiverse
Google Hub Corner Mount
12
Downloads
12
Likes
0
Makes
A corner mount for the Google Hub 2nd Gen display unit (does not fit a Google Hub MAX). I designed it for our bathrooms, to mount the Hubs up in the corner by the ceiling. It angles the display down to 90 degrees so you can see it better, and has a tray in the back to coil excess cable.
The back is a bit flimsy, so be careful screwing it into the wall. I cracked mine being too zealous with the power drill. Also be aware that the corner of your room might not be 100% square, so the sides might not sit flush to the walls. If I were to do it again, I would have sliced the back corner of the box so that it did not contact the very corner of the walls. Was good enough for me, so I'm done with this one.
Original design, designed in Fusion360
The back is a bit flimsy, so be careful screwing it into the wall. I cracked mine being too zealous with the power drill. Also be aware that the corner of your room might not be 100% square, so the sides might not sit flush to the walls. If I were to do it again, I would have sliced the back corner of the box so that it did not contact the very corner of the walls. Was good enough for me, so I'm done with this one.
Original design, designed in Fusion360
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
