Slicer Discord
Google Wifi 1st generation wall mount – 3D-Druckmodell von MakerWorld MakerWorld
Electronics

Google Wifi 1st generation wall mount

469 Downloads
49 Likes
369 Makes
Zum Modell
Original model made by aalcock @ Thingiverse: https://www.thingiverse.com/aalcock/designsFor 1st gen Google WiFi “pucks” only, the original creator (link above) made a great install instruction picture, but in short:- install at the desired location with tape or screws- seat the puck's cable exit side to the 2 smaller tabs- click the other side of the puck under the lip of the big tabAdded two holes to the model for screw mounting, but can still be attached with a double sided tape, powerstrips, velcro strips etc.3 walls and 25% 3D honeycomb infill for some rigidity, roughly 10 grams more with 100% infill. Supports for overhangs, check that these are on.
Kategorie
Electronics
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
ABS
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen