Thingiverse
Goomba (for printing without support)
door The_Oddler
34
Downloads
25
Likes
0
Makes
A goomba that can be printed without support. It does however is broken up in two parts to allow this, so some glue will be needed.
I altered Little Goomba by 7777773
What I did to allow this:
1) As I already said, cut it in two.
2) Slightly altered the feet to better support its body, very minor and almost impossible to see.
3) Removed the eyebrows since they were just floating around. Next version will add these again, but against its body.
4) Filled its mouth.
5) Flattened the underside of its head slightly.
Original: http://www.thingiverse.com/thing:18526/#files
I altered Little Goomba by 7777773
What I did to allow this:
1) As I already said, cut it in two.
2) Slightly altered the feet to better support its body, very minor and almost impossible to see.
3) Removed the eyebrows since they were just floating around. Next version will add these again, but against its body.
4) Filled its mouth.
5) Flattened the underside of its head slightly.
Original: http://www.thingiverse.com/thing:18526/#files
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!