Thingiverse
GoPro 10 floating case
door fermit
9
Downloads
8
Likes
0
Makes
This is a GoPro Hero 9/10 floating case.
This must be printed with TPU (flexible) filament, so that the case can flex to push in the camera (and not scratching it).
This case will keep the GoPro floating, however this depend also on what accessories you attach. Try it out in a bucket before before real-life use.
Flip out the mounting fingers before putting the camera into the case.
It is crucial to keep the case light, it requires however 10% infill to support the top layers.
Support is required, so the button cut-out is printed nicely.
[Here is a long thumb screw](https://www.thingiverse.com/thing:5445462) for mounting the GoPro while in the case.
This must be printed with TPU (flexible) filament, so that the case can flex to push in the camera (and not scratching it).
This case will keep the GoPro floating, however this depend also on what accessories you attach. Try it out in a bucket before before real-life use.
Flip out the mounting fingers before putting the camera into the case.
It is crucial to keep the case light, it requires however 10% infill to support the top layers.
Support is required, so the button cut-out is printed nicely.
[Here is a long thumb screw](https://www.thingiverse.com/thing:5445462) for mounting the GoPro while in the case.
fermit publiceert ook op
34 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
