Thingiverse
GoPro Gorillapod mount
von PandPP
33
Downloads
22
Likes
0
Makes
I printed tkramm's version at 0.3mm layer height, but it wouldn't fit into the Gorillapod.
After I started looking I wasn't happy with the accuracy of the Gorillapod base. The result is that I redesigned the Gorillapod base.
I also wanted the 5mm nut holder to fully capture the nut.
I printed this with support, due to the large overhang on the captured nut.
The slope on the Gorillapod base is 0.4mm over 31.5mm. If you don't print this at hi-res, it quite likely will not fit.
Sorry about the average photos.
After I started looking I wasn't happy with the accuracy of the Gorillapod base. The result is that I redesigned the Gorillapod base.
I also wanted the 5mm nut holder to fully capture the nut.
I printed this with support, due to the large overhang on the captured nut.
The slope on the Gorillapod base is 0.4mm over 31.5mm. If you don't print this at hi-res, it quite likely will not fit.
Sorry about the average photos.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
