Thingiverse
GoPro Mount for Ultimaker
von C3dke
54
Downloads
39
Likes
0
Makes
GoPro Mount for the Ultimaker - based on the mount from idanshemtov.
Smaller so that lesser material is needed.
Opening is a little bit bigger so that insertintg the GoPro head-piece is easier.
Trimmed the pieces sticking inside the printer to be sure that there is no collision with the printer head while printing full range.
Smaller so that lesser material is needed.
Opening is a little bit bigger so that insertintg the GoPro head-piece is easier.
Trimmed the pieces sticking inside the printer to be sure that there is no collision with the printer head while printing full range.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!