GoPro Ring Box

This is a simple box that holds a GoPro Hero Session 5 and has a compartment to hold a ring or other object.

The cover has tabs at the top to assist with attachment. Both the box and the cover feature recessed 2x3mm holes for these magnets:
https://www.amazon.com/gp/product/B0819JZF66/ref=ppx_yo_dt_b_asin_title_o07_s01?ie=UTF8&psc=1

Note: you may need to increase the model size to 101% or so as my CR10s Pro printed these holes slightly smaller than 2mm width (~.15-.2mm variance).

A GoPro Hero 5 Session fits perfectly, but the rubber coating may reflect rubbing from the tight fit (it doesn't cause any damage).

For the box I used a cross design so that I could inject the body with filler foam to increase buoyancy. The 2mm holes on the bottom of the box are injection ports once you punch them in (there's 1-2 layers of material capping the ports).

Print settings:

Box:

- 15% infill (Cross design)
- .30 layer height
- Bed @ 60C
- Print speed - 90mm/s

Handle/Cover