Thingiverse
GoPro Screw-Type Base
von Blackmonm
39
Downloads
17
Likes
0
Makes
Printed with a direct drive Ender 3 Pro and Cura slicer
Print Settings:
Layer Height: .16
Infill: 60%
Speed: 60mm/s
No Supports
Printed with raft but not required
The holes are set for a socket head type bolt with a 10mm diameter head that is 8mm deep and a shank of 6mm with 0.8mm clearance given for the shank on this model.
Enjoy !
Print Settings:
Layer Height: .16
Infill: 60%
Speed: 60mm/s
No Supports
Printed with raft but not required
The holes are set for a socket head type bolt with a 10mm diameter head that is 8mm deep and a shank of 6mm with 0.8mm clearance given for the shank on this model.
Enjoy !
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
