GoPro Session 5 Proframe Chin Insert

A chin insert for Fox Proframe Helmet build for GoPro Session 5.

USE WITH YOUR OWN RISK. Probably will hit your chin if something happened, make sure you have enough clearance from your chin.

Print it with flexible filament.

Installation :
- Install Session 5 from hole in front of insert.
- It will very tight fit when it's done.
- Just push the insert into Proframe's chin hole, it will also tight fit in it.
- Top edge from the insert normally flush with top edge of the foam of chin hole Proframe's to have a good visibility for the video. If the angle not enough you can fine tune by pushing the insert in or out.

I made this with Medium size helmet and only have this size, I don't know if it's possible to install this into Small size helmet. Either with Large size helmet.

To be able to operate the Session 5 you have use a GoPro's Remote or GoPro's app. But you can still push all buttons to record a video because the insert is flexible, you have to do this before put