Thingiverse
GOT Stark Key Rack
von KCPA
37
Downloads
33
Likes
0
Makes
Designed to be printed on the Creality CR10S Pro which has a large print bed. (300x300)
Fusion 360 file has been included so that you may modify as desired. The print pictured was started with Silver filament and then as the wolf started to print, I switched to the copper filament. The castle turrets are attached via (8) #6 screws.
If you do scale it down at all, don't forget to also scale the corner screw covers. Otherwise they will not snap into place properly.
Fusion 360 file has been included so that you may modify as desired. The print pictured was started with Silver filament and then as the wolf started to print, I switched to the copper filament. The castle turrets are attached via (8) #6 screws.
If you do scale it down at all, don't forget to also scale the corner screw covers. Otherwise they will not snap into place properly.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!