Gotek Screenholder With overhang

Remix of https://www.thingiverse.com/thing:4863653

This helpful little shim will help you replace the stock 7 segment display in a standard gotek with a 128x23 oled. It will hold the display in place without the need for hot glue or any kind of adhesive. (You will need to replace the stock firmware with flashfloppy. Read all about it here: https://github.com/keirf/flashfloppy)

Slightly modified from the original to add an overhang to help keep the oled screen in place better. I found sometimes the screen could shake or jiggle upward and make the screen difficult to read. It's also now tall enough that the top shell will hold it snugly when in place. I measured all of my little oleds to be 12mm wide and they fit snugly with just a little bit of wiggle room for error.

Downside compare to the original is you'll need to print with supports.

As with the original design you'll have to remove the tabs on the top of the shell as they won't fit with the holder in place.