Gotway Tesla Stand

This stand is of minimalistic design using the Tesla's shims as the main contact point. It also features a water drainage reservoir for those post wet ride occasions and two insets on the bottom just big enough to hold a 3M Command Strip to keep it in place, though they are not necessary (my robot vacuum likes to cause trouble otherwise).

My printer is the Ender 3 so I made the stand as large as I could without going beyond my maximum printing area. Just make sure the model is centered in your slicer before you make the gcode. You will need supports due to the insets on the bottom.

Hope you like it, tell me what you think in the comments!

Happy Making and keep the rubber side down!