Thingiverse
Govee Lightbar Extender
door Asleep3D
0
Downloads
1
Likes
0
Makes
This is for boosting up a Govee Lightbar from the Govee TV Lightbar/Light Strip/Camera set.
By default, it boosts it up by 100mm, and there are options for a flat body, angled 10deg body, or a 20deg one. Feel free to adjust the height of it in FreeCad, but you may want to make the base a bit bigger so it does not fall.
I am using this to illuminate my prints during a timelapse as I do not have any other use for the lightbars.
Feel free to leave any suggestions in the comments. I am relatively new to 3D design and would like some constructive criticism on this model :)
By default, it boosts it up by 100mm, and there are options for a flat body, angled 10deg body, or a 20deg one. Feel free to adjust the height of it in FreeCad, but you may want to make the base a bit bigger so it does not fall.
I am using this to illuminate my prints during a timelapse as I do not have any other use for the lightbars.
Feel free to leave any suggestions in the comments. I am relatively new to 3D design and would like some constructive criticism on this model :)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!