GPD Win Alt Bottom

Here is a Design shared by Pintek over on Dingoonity in the GPD Win Thread. Looks great. Can allow for other Batteries, or if you want, can possibly allow for an alternate Fan. However, I was recently informed, it could take up to 5-6 Hours to Print depending on your 3D Printer/Software, and there are a few Sections that are Small. Apparently some Printers can not Print 7-8mm thickness that well. So be warned.
With this Design, it can house a Stock Battery (If you can get a Replacement from GPD or the Battery Company), or you can use a thicker Battery, or a 10mm thick sunon alternative 25mm fan from what Pintek says. So this does look like a real good Design. But there might be a Issue.
"it mostly checked out on shapeways a few thin spots here an there but with a hobby knife could shave material and it be HIGHLY recommended to sand the exterior I haven't put a order in yet waiting for payday to see how it comes out."