Slicer Discord
GPS Tracker TK102B ON/OFF SHELL – 3D-Druckmodell von Thingiverse Thingiverse

GPS Tracker TK102B ON/OFF SHELL

von spelli
3 Downloads
2 Likes
0 Makes
Zum Modell
The GPS Tracker TK102B is widely used. You get it for about $ 13 to $ 15.

The factory setting does not allow autostart. For some GPS trackers, I have bypassed the ON / OFF button (this is easily done by loosening the screw under the "QC PASSED" seal and taking the board out halfway).

Now I've made a shell that holds the ON / OFF button when plugged in. So the GPS Tracker always starts automatically when 5V USB voltage is applied.

It saves you almost pressing the button to start. To switch off the button must be pressed again.

In different colors you can keep track of different trackers!
The bow has become a bit ugly...

0.2
20%
no support
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Warum?
keine Supports
Ohne Supports Einteilig Hardware nötig
Supports 0/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen