GPSMAP66 handlebar support 22mm
por BC3ds
3
Descargas
6
Likes
0
Makes
This is a mount to adapt a GARMIN GPSMAP66 or compatible to a 22mm bike handlebar, via a RAMMOUNTS-adapter.
Get it at
https://rammount.com/products/ram-hol-ga76u,
https://rammounts.de/part/ram-hol-ga76u
RAMMOUNTS-adapter will be tough to get of, so check where to take off some material to make it easier.
See picture attached, indicating the area which could be grinded down a bit.
You will need the screws and nuts that come with the RAMMOUNTS-Adapter, which is 2x the M4x13.
Additionally for the handlebar clamp, 2x M4x18 or M4x20.
Bore is designed to 22.1mm, but should turn out tighter. It fitted perfect after my first print.
Just clamped enough when the two halfs were tightened together without a gap.
Maybe use a washer when the screw's head it quite small.
Hope you like it!
Best regards from
Bernd's Custom 3D's.
Get it at
https://rammount.com/products/ram-hol-ga76u,
https://rammounts.de/part/ram-hol-ga76u
RAMMOUNTS-adapter will be tough to get of, so check where to take off some material to make it easier.
See picture attached, indicating the area which could be grinded down a bit.
You will need the screws and nuts that come with the RAMMOUNTS-Adapter, which is 2x the M4x13.
Additionally for the handlebar clamp, 2x M4x18 or M4x20.
Bore is designed to 22.1mm, but should turn out tighter. It fitted perfect after my first print.
Just clamped enough when the two halfs were tightened together without a gap.
Maybe use a washer when the screw's head it quite small.
Hope you like it!
Best regards from
Bernd's Custom 3D's.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!